Wingnut Custom Night Radian LED Controller with Switchable Light Options & Variometer Light Display
The FT Night Radian LED Controller is designed to replace the original LED sequencer that came preinstalled in the FT Night Radian. The original controller was good, but all the LED strings were treated exactly the same. This new LED Controller addresses each string individually, left wing, right wing, nose, fuselage, and tail. This means more extravagant light shows, as well as lighting up parts of the plane differently. It also will allow you to switch between several new user-selectable LED “shows” right from your transmitter. It works best if you have a rotary knob that you can assign to the channel, but will work easily with a 3-position or even a 2-position switch. This unit also frees up your battery balance connector, since it is completely powered from your receiver’s 5-volt feed.
This new LED controller gives you the option of enabling navigation lights on your model for easier orientation when flying in low light or nighttime conditions. This mode turns the wingtips red and green, and also strobes the wingtips white, mimicking full-scale aircraft navigation lights.
This LED controller also includes an altitude sensor that will indicate how high the model is flying above ground level (AGL) by lighting up more wing LEDs as your altitude increases. Zero feet AGL has zero LEDs lit. 600 feet AGL has all the wing LEDs lit. It also provides a vertical speed indicator (variometer) that will cause the tail LEDs to remain white during level flight, but will change to green when climbing and red when descending, in varying intensity depending on your rate of climb/descent.
In the Box.
A replacement LED controller for the E-Flite Night Radian FT, allowing complete control of the LED patterns from a separate channel on your RC transmitter.
ATTENTION: If you have the Bind ‘n Fly version of the Night Radian with the Spektrum AR636 receiver, please be aware that the extra channels on this receiver are disabled. You will need to enable one of these extra channels in order to add any accessories to this receiver. This not a limitation of, or is in any way caused by this LED controller
Please Note: As this item is being constantly updated please update the software should you want the latest version using the link below.
|Manufacture's Part Number||No|